Installation Guide

4
LEFT
HINGE
SHOWN
RIGHT
HINGE
SHOWN
5
6
7 8
Locate the rail extenders. Slide the rail extender into the
bottom of the hinge rail. For LEFT HINGE installation, use
the rail extender marked with an “L”. For RIGHT HINGE
installation, use the rail extender marked with an “R”.
Slide the bottom expander onto
the bottom of the door, with the
slots to the interior. Do NOT
secure with screws at this time.
Locate the screw template in Bag A of the Closer
Kit. Position it with the proper end UP based on your
hinge position. Place the template tight against the
hinge side of the door frame, and slide to the top.
Holding the template in place, install the
placeholder screw into the center of hole. Do not
tighten all of the way. Leave 1/8-in of the screw
exposed. Remove and discard template.
Left Hinge
Right Hinge
Left Hinge
Right Hinge
Actual Size
Placeholder Screw
#8 x 3/4” Pan Head
Qty.
1