User Guide

TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS:

Cut and remove the strap that runs from the door lock to the sill of the door.

C. Insert the door from the exterior of the

building.

DO NOT slide the bottom of the

door into the opening. Sliding will damage

the sealant lines. Place the bottom of the door

at the bottom of the opening, then tilt the

top into position. Center the door between

the sides of the opening to allow clearance for

shimming, and insert one roong nail in the

rst hole from the corner on each end of the

top nailing n. ese are used to hold the door

in place while shimming it plumb and square.

Plumb and square door. Place shims at each

hinge and lock strike location between the

door and the sides of the opening. Insert shims

in other locations as needed starting up 6”

from the bottom of the door to square it in the

opening. Make sure that the reveal around the

door(s) is equal. On double doors, make sure

that panels are even across the bottom.

Note: On center latch double doors the lock

strike will not be shimmed since it is located in

the center of the unit. DO NOT over shim.

Interior

2 0 3 0 4 0 5 0 6 0 7 0

2 3

INCHES

Exterior

E. Check the interior reveal. Make sure the measurement from the interior face of the door to

the interior face of the wall is equal at several points around the door.

Note: If the dimensions are not equal, check to make sure the ns are folded out to 90° at all

points.

DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS