Installation Guide

A.
11A
Horizontal
Screw
Cover
Vertical
Screw
Cover
11 EXTERIOR SCREW COVERS
B.
C.
12GLASS AND ROLSCREEN OPERATION
A.
Push
Sash Lock
To Unlock
Sash
Unlocking the glass panel - press the sash
lock button inward as shown and lower the
glass panel. Slide the upper glass panel to
any position for ventilation preference.
Remove the shipping block(s) located between the top
of the sash and the Rolscreen cover.
Note: The Rolscreen is attached to the
top of the glass panel and will fill the
ventilation area as the glass is lowered.
Note: The Rolscreen will automatically
retract as the glass slides upward.
Note: Cut the vertical screw covers to match the length of the mounting frame by
scoring with a utility knife, then snapping in two.
®
Glass
Installation
Position
Adjustment
Screw
10U
Open the door and check the closer speed. The speed of the door
closer may be adjusted by turning the adjustment screw. Turn the
screw clockwise to reduce the door closer speed or counter clockwise
to increase the door closer speed.
U.
10 DOOR CLOSERS (CONTINUED)
Locking the glass panel - Slide the
exterior glass upward and the sash lock
will automatically engage.
12B
12C
Sash
Handle
Screen (Attached)
®
10
Screw Covers: Starting flush at one end, install the horizontal screw cover strip by inserting the angled
edge into the outer most track and pressing in place. Repeat this procedure for the two vertical screw
covers starting at the top of the mounting frames.