Installation Guide

B.
BEFORE YOU BEGIN
B. Record the door's registration number
for future reference.
Note: The door's registration label is
located on the edge of the door frame.
C.
1 ENTRYWAY OPENING PREPARATION
A.
Registration Number:
Door Model Number:
(see carton label)
W
A
R
R
A
N
T
Y
R
E
G
.
#
D
O
N
O
T
R
E
M
OV
E
3
6
.
3
7
5
X
7
8
.
6
2
5
P
A
T
E
N
T
P
E
N
D
I
N
G
02203 902
215 23019
Registration
Label
Left Hinge
Doors
Right Hinge
Do
ors
Shim
Shim
Shim must not extend
beyond entryway
Hinge
1B
Remove the door from the carton.
A.
Determine which side you want your storm
door to hinge when viewed from the exterior of
your home.
If required, shim the entry door frame. Using four shim
sections each about 8" to 12" long, position to align with the
hinges on the storm door. DO NOT extend the shim beyond the
face of the entryway.
Verify the door will fit in the entryway opening. Measure the width of
the opening in three locations. Using the smallest measurement, refer to
the chart for shimming requirements and shim accordingly.
Note: Before discarding the carton, make sure ALL
parts are accounted for. Check the carton roll-ups
at the top and bottom.
Entry Door
1A
B
2