Installation Guide

4B
G.
3 HINGE MOUNTING FRAME ASSEMBLY (CONTINUED)
H.
3G
3H
S
ill
Angle
s
I
nterior
E
xterior
Interior
3G
L1
L2
B.
C.
4 BOTTOM EXPANDER ASSEMBLY
4A
S l i d e
EXTERIOR
Slide
4E
A. Slide the black vinyl sweep along the full length of the bottom expander.
Note: Some models have two sweeps.
D.
Place the bottom expander onto the bottom of the door
with the sweep toward the interior. DO NOT install screws in
the bottom expander at this time, adjustments are made in a
later step.
Note: Models with two sweeps have a notched bottom
expander to match the door frame. Position the notch to
the interior.
4C
Lock the sweep in place by pinching the ends of the
inner legs.
Interior
Side
E.
For models with two sweeps, cut away a 1/2" wide notch
from both ends of the interior sweep.
4D
4E
Tu rn the door over so the exterior faces up. Starting at the
top of the hinge mounting frame and working toward the
bottom, measure and mark the lengths L1 and L2 taken from
the previous step.
Black
Vinyl
Sweep
Straight
Cut
Angle
Cut
L1
Notch
Matching the angle of your entryway sill, cut the bottom of
the hinge mounting frame to length.
Note: For a simplified installation, a straight cut at L1 may
be made. For a more professional looking installation, an
angled cut from L1 to L2 may be made.
Cut the excess sweep from each end.
4
1
/
2
”