Installation Guide

E .
A.
B.
C.
D.
ST
O
R
M
D
O
O
R
Short Closer Pin
Long Closer
Pi
n
10B
10C
10D
1/16"
10E
On the hinge side of your entryway, position a jamb
closer bracket even with the top of the bottom expander,
(see the dotted line in the illustration) and 1/4" back from
the mounting frame. Mark the screw hole locations and
drill 1/8" diameter holes.
1/4"
back
Even with Top
Hold Open Washer
10A
Install the bottom jamb closer brackets using four jamb
bracket screws (#10 x 1" Phillips pan head) for each bracket.
Jamb Closer
Bracket Screws
Pull
Attach the door closer to the door closer bracket using the
long closer pin in the "glass use" position (see Step 10U) and
turn the adjustment screw counter clockwise 4 to 5 turns.
Bottom
Expander
Adjustment
Screw
Door Closer
Door Closer Tube
Pull the door closer tube and slide the hold open
washer onto the door closer rod past the lugs.
Adjust the hold open washer to achieve a distance of
1/16" between the hold open washer and lugs.
Door Closer
Rod
Slide the hold open washer onto the door closer rod
and attach the door closer rod to the jamb closer bracket
using the short closer pin.
Lugs
Door Closer Rod
Door
Closer
Bracket
Jamb
Closer
Bracket
Adjustment
Screw
10D
Glass Use
Position
10 DOOR CLOSERS
9
DOOR HANDLE HARDWARE
A.
9A
7
Jamb
Closer
Bracket
Hold Open
Washer
Handle Hardware: To install the handle assembly, refer to the
separate instruction sheet included in the handle hardware box.