Installation Guide

L.
Measure the distance from the hinge side of the entryway to
the end of the bottom door closer bracket. Mark this end distance
on the label located near the top of the door.
Position the bottom edge of the top door closer bracket
on the dashed line of the label located near the top of the
door panel.
M.
Entry
Door
Jamb
Hinge
Side
10L
10M
Note: For doors with a yellow ("Do Not Drill") label at the top of the door panel,
go to step L. For doors without a yellow label, follow steps H through K.
H.
J.
Measure the distance from the hinge side of the entryway to
the end of the bottom door closer bracket. Mark this end distance
approximately 2" from the top of the door.
Measure down 2" from the top of the door panel and draw a
1" long line on the door panel towards the jamb hinged side.
I.
Position the end of the door closer bracket on the line from
step H. Mark the screw locations for the top door closer
bracket. Center punch and drill 1/8" diameter pilot holes.
Proceed to step O.
10H
Entry
Door
Jamb
Hinge
Side
10I
Position the bottom edge of the top door closer bracket on
the line from step I.
K.
F.
10F
10G
With the door tightly closed, align the bottom
door closer bracket with the top of the bottom
expander. Mark the centers of the hole pattern.
Center punch and drill 1/8" diameter holes through
the interior face of the door.
Install the door closer bracket
with two door closer
bracket screws (#10 x 5/8" Phillips pan head).
G.
Door Closer
Bracket Screw
Door
Closer
Bracket
Long Closer
Pin
Bottom
Expander
10 DOOR CLOSERS (CONTINUED)
1" Line
2" Down
8
Door
Closer
Bracket
Door
Closer
Bracket
Label