Installation Guide

Latch
Mounting
Frame
Door
Hinge
Mounting
Frame
Top Mounting Frame/
Drip Cap
Hardware Kit
Door Closers
Includes mounting
screws and some
handle components
Bottom Expander
Extenders
Registration
Number
This is your door’s
identification number.
Leave this sticker on
your door.
Handle Hardware Kit
Includes mortise lock,
hinge installation screws
and 7/8” spade bit
Retractable Screen
Handle Kit
2
Storm Door Components
NOTE: Actual door styles may vary from illustrations, however, the installation steps will be the same.
Before you begin
Make sure brickmold trim is in good condition and securely fastened before beginning installation.
It is highly recommended that additional fasteners be used to reinforce brickmold trim.
Shimming may be required to fit existing opening (shims not included). Measure the width of the opening in
three locations. Using the smallest measurement, refer to the chart below and shim as needed.
1 in. wide x 1 in. deep mounting surface is required.
Standard
Door Sizes
Min–Max
Doorway Width
Min–Max
Doorway Height
32 in x 81 in 31-7/8 to 32-3/8 in
80 to 81 in
36 in x 81 in 35-7/8 to 36-3/8 in
30 in x 81 in 29-7/8 to 30-3/8 in
34 in x 81 in 33-7/8 to 34-3/8 in
1 in.
1 in.
TOP VIEW
Exterior Brick Mold Trim
Storm Door Opening Width
Jamb
Interior House Door