Installation Guide

6
7
Install your handleset
a The handle template is pre-applied to the door. Drill holes as shown on template.
Drill from each side; do not drill straight through. Remove template after drilling.
b Follow handle instructions in handle hardware kit.
6A Slide rail extender into the bottom
of latch rail.
6D Verify that the door closes freely
without hitting the latch rail. Align
outside edge of latch rail with outside
edge of drip cap.
Install Latch Rail (Right Hinge shown)
6
6B Place latch rail tight against the
drip cap.
6E Starting at the top hole, predrill and
fasten the latch rail with a #8 x 1” screw.
Align the edge of the door panel and
mounting frame from top to bottom.
Continuing down the latch rail, predrill
and install one screw at a time, keeping a
consistent reveal.
6C Slide rail extender to sill.
6F Cut extender weather stripping
to length, peel adhesive backing and
install.
Right side shown
#8x1 in.
painted
1/8 in.