Installation Guide

9
10
Finishing Touches continued Door Closers
10A On the hinge side of your
entryway, position a jamb closer
bracket even with the top of the
expander, (see the dotted line in the
illustration) and 1/4" back from the
mounting frame. Mark the screw hole
locations and drill 1/8" diameter holes.
10D Attach the door closer
bracket to the door closer by
removing the O-ring and pin,
then reinserting the pin.
10B Install the bottom jamb closer
bracket using four jamb bracket screws
(#10 x 1-1/2" Phillips pan head).
10E With the door tightly
closed, align the bottom door
closer bracket with the top of
the bottom expander. Mark
the centers of the hole pattern.
Center punch and drill 1/8"
diameter holes through the
interior face of the door.
10C Attach the bottom closer (with One-
Touch
®
button) rod to the jamb bracket
using the short closer pin, then pull
the door closer and slide the SHORT
spacer clip onto the closer rod as shown.
Position the closer so the One-Touch
®
button is along the top of the closer.
10F Install the door closer
bracket with two door
closer bracket screws (#10
x 5/8" Phillips pan head).
1/4"
back
poT htiw nevE
Expander
Jamb
Closer
Bracket
O T S M R
O
O D
R
Short Closer Pin
Jamb Closer
Bracket Screws
Door Closer
Door Closer Rod
Door
Closer
Bracket
Adjustment Screw
Short Spacer Clip
Long Closer Pin
One-Touch
®
Button
Long Closer Pin
d r a c s i D
t r e s n I
e v o m e R
Door Closer
Bracket Screw
Door
Closer
Bracket
Long Closer Pin
Bottom
Expander
Short Spacer Clip Short Closer Pin
#10x5/8 in.
#10x1-1/2 in.
10G Discard spacer clip
from the closer rod.
R O O D M R O T S
e v o m e R
d n a
d r a c s i D
Spacer Clip