。 PELONIS� en USER MANUAL Dehumidifier DP&DL Rated voltage: 115V Frequency: 60Hz Warning notices: Before using this product, please read this manual carefully and keep it for future reference. The design and specifications are subject to change without prior notice for product improvement. Consult with your dealer or manufacturer for details. PAD20C1AWT PAD30C1AWT PAD40C1AWT PAD50P1ABL PAD60P1AGR Customer service: 1(866) 646-4332 www.pelonis.
Owner’s Manual 0 Safety Precautions ............................................................................ 3 1 Unit Specifications and Features ................................................... 6 2 Operating Instructions ..................................................................... 7 3 Installation Instructions ................................................................... 13 4 Care and Cleaning ...........................................................................
Safety Precautions Safety Precautions To prevent injury to the user or personal and property damage, these instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The level of risk is shown by the following indications. This symbol indicates the possibility of death or serious injury. WARNING This symbol indicates the possibility of injury or damage to property. CAUTION WARNING • Plug in power plug properly.
Safety Precautions CAUTION • Do not use the unit in small spaces. Lack of ventilation can cause overheating and fire. • Do not use in places where water may splash onto the unit. Water may enter the unit and degrade the insulation. It may cause an electric shock or fire. • Place the unit on a level, sturdy section of the floor. If the unit falls over, it may cause water to spill and damage belongings, or cause electrical shock or fire.
Safety Precautions WARNING - Electrical Information • The manufactures nameplate is located on the rear panel of the unit and contains electrical and other technical data specific to this unit. • Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is equipped with a three-prong grounding plug for protection against shock hazards. • Your unit must be used in a properly grounded wall receptacle.
Unit Specifications and Features Unit Specifications and Features 1 Product overview Control panel Handle(both sides) Air outlet grille Air filter Panel Continuous drain hose outlet Water level window Power cord buckle(placed in the water bucket,used only when storing the unit) Pump drain hose outlet(some models without) Caster Water bucket Power cord and plug Air outlet grille Control panel Handle(both sides) Continuous drain hose outlet Power cord buckle(placed in the water bucket), used only wh
Operating Instructions 2 CAUTION Key Pad Features NOTE The appearance of the control panel on your unit may vary slightly. Functions will be similar. Control Pads When you push the button to change operation modes, the unit will make a beep sound to indicate that it is changing modes. (PUMP) Button Press to activate the pump operation. Page 7 Operating Instructions Clean your unit occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards.
NOTE Operating Instructions Make sure the pump drain hose is installed into the unit and the continuous drain hose is removed from the unit before the pump operation is activated. When the bucket is full, the pump starts to work. Refer to the next pages for removing the collected water. Do not use this operation when the outdoor temperature is equal to or less than 0°C (32°F). (COMFORT) Button Press to activate the COMFORT dehumidifying operation.
Eb - Bucket is removed or not in right position - Replace the bucket in the right position. (only available for the unit with pump feature.) P2 - Bucket is full - Empty the bucket. (only available for the unit with pump feature.) Other Features Bucket Full Light Auto Shut Off The dehumidifier shuts off when the bucket is full, or when the bucket is removed or not replaced in the proper position. When the set point humidity level is reached, the unit will be shut off automatically.
Removing Collected Water There are three ways to remove collected water: 1. Use the bucket Operating Instructions • When the unit is off, if the bucket is full, the Full indicator light will light. • When the unit is on, if the bucket is full, the compressor and the fan turn off, and the Full indicator light will light, the digital display shows P2. • Slowly pull out the bucket. Grip the left and right handles securely, and carefully pull out straight so water does not spill.
2. Continuous draining Water can be automatically emptied into a floor drain by attaching the unit with a standard garden hose thread to the back of the dehumidifier. The hose should have an outside diameter 5/8 inch or greater. Garden hose is not included. • Remove the plastic cover from the back drain outlet of the unit and set aside, then insert the drain hose through the drain outlet of the unit and lead the drain hose to the floor drain or a suitable drain facility. (See Fig. 9 and Fig.
NOTE The pump may generate a loud noise for the first 3~5 minutes of operation. Operating Instructions • Make sure the hose is secure so there are no leaks. • Direct the hose toward the drain, making sure that there are no kinks that will stop the water flowing. • Place the end of the hose into the drain. • Select the desired humidity setting and fan speed on the unit for pump draining to start. NOTE The pump operation light blinks when a failure occurs.
3 Installation Instructions Positioning the Unit A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed storage area, such as a closet, unless there is adequate circulation of air in and out of the area. (See Fig. 13) Do not use outdoors. This dehumidifier is intended for indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications.
Care and Cleaning 4 Turn the dehumidifier off and disconnect the plug from the power source before cleaning. 1. Clean the Grill and Case • Use water and a mild detergent. Do not use bleach or abrasives. • Do not splash water directly onto the unit. Doing so may cause an electrical shock, cause the insulation to deteriorate, or cause the unit to rust. • The air intake and outlet may get dirty during operation, use a vacuum cleaner or brush to clean. 2.
5 Troubleshooting Tips Before calling for service, review this list. It may save you time and money. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Problem Solution and/or Cause Make sure the dehumidifier’s plug is connected firmly into the wall outlet. Unit does not start Check the house fuse/circuit breaker box. Dehumidifier has reached its present level or bucket is full. Empty the bucket and dump.
Warranty Dehumidifier Limited Warranty Your product is protected by this Limited Warranty: Warranty service must be obtained from Midea Consumer Services or an authorized Midea servicer. Warranty • Three years limited warranty from original purchase date. Midea, through its authorized servicers will: • Pay all costs for repairing or replacing parts of this appliance which prove to be defective in materials or workmanship.
。 PELONIS�