Use And Care Manual

 Page 9 
Bucket Full Light
Lights up when the bucket is ready to be
emptied.
Auto Shut Off
The dehumidifier shuts off when the bucket
is full, or when the bucket is removed or not
replaced in the proper position. When the
set point humidity level is reached, the unit
will be shut off automatically. The fan motor
will continue operating.
Auto Defrost
When frost builds up on the evaporator
coils, the compressor will cycle off
and Auto Defrost function will run
automatically.
3 minute compressor operation delay
protection
After the unit has stopped, it can not be
restarted in the first 3 minutes to protect
compressor operation. The unit will restart
automatically after 3 minutes.
Auto-Restart
If the unit stops unexpectedly due to a
power cut, it will restart with the previous
function setting automatically when the
power resumes.
Setting the Timer ON and Timer OFF
• Press or hold the
and key buttons
to change the Timer by 0.5 hour
increments, up to 10 hours, then at
1 hour increments up to 24 hours.
The control will count down the time
remaining until start.
• The selected time will register
in 5 seconds and the system will
automatically revert back to display the
previous humidity setting.
• Wh
en the Timer ON and Timer
OFF times are set, within the same
program sequence, indicator lights
illuminate identifying both ON and
OFF times are now programmed.
• Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0 will
cancel the Timer function.
• When LED display window displays
the code of P2, the Auto Start/Stop
function will also be canceled.
NOTES
• When first using the dehumi
difier,
operate the unit continuously 24
hours. Make sure the plastic cover
on the continuous drain hose outlet
install tightly and properly so there
are no leaks.
• This unit is designed to operate with
a working environment between
5°C/41°F and 32°C/90°F.
• Make sure the water bucket is
positioned correctly so that the unit
can operate properly. When the
water in the bucket reaches a certain
level, please be careful while moving
the unit to avoid it spill.
Operating
Instructions
Other Features
• When the unit is on, first press the
Timer button, the Timer OFF indicator
light illuminates. It indicates the Timer
OFF program is initiated. Press it again
the Timer ON indicator light
illuminates. It indicates the Timer ON is
initiated.
• When the unit is off, first press the
Timer button, the Timer ON indicator
light illuminates. It indicates the Timer
ON program is initiated.
P2 - Bucket is full - Empty the bucket.
(only available for the unit with
pump feature.)
Eb - Bucket is removed or not in right
position - Replace the bucket in the
right position. (only available for the
unit with pump feature.)
Press it again, the Timer OFF
indicator light illuminates. It indicates
the Timer OFF is initiated.