Use And Care Manual

 Page 16 
6
INSTALLATION INSTRUCTIONS
CAUTION
• There are sharp edges that can
cause serious cuts.
• When lifting the air conditioner, it is
HEAVY. Use 2 people to lift.
• For existing sleeve, you should measure
the wall sleeve dimensions.
• Install the new air conditioner according
to these installation instructions to
achieve the best performance. All wall
sleeves used to mount the new air
conditioner must be in good structural
condition and have a rear grille that
securely attaches to the sleeve or the
flange of the sleeve to secure the new
air conditioner.
• To avoid vibration and excess noise,
make sure the unit is installed securely
and firmly.
• When installing the sleeve, make certain
there is nothing within 20” of the back
of the unit that would interfere with
heat radiation and exhaust air flow (see
Fig. 6).
HOW TO INSTALL THE UNIT PREPARATION OF SLEEVE ASSEMBLY
(optional)
Refer to the installation instruction of
sleeve assembly for details.
PREPARATION OF REAR GRILLE
ASSEMBLY (optional)
Refer to the installation instruction of rear
grille assembly for details.
UNIT INSTALLATION
• Carefully remove shipping tape from
the front panel (see Fig. 7).
Installation
Instructions
COOLED
AIR
INTAKE
AIR
WALL
WALL
HEAT
RADIAT ION
SLEEVE
Over 20”
Fig. 6
Fig. 7
16 in/408 mm
16 in/408 mm
14.8 in/376 mm
42 in/1067 mm
23.9 in/606 mm
Shipping
tape
Dimension of air conditioner
Dimension of sleeve assembly (optional)
42 in/1067 mm