Use And Care Manual

 Page 11 
3
DIP SWITCHES CONFIGURATIONS
REMOVING THE FRONT PANEL
• Dip switches controls are located behind
front panel, through an opening below
the control panel. To access, remove
front panel. See Fig. 2.
• Dip switches are accessible without
opening the control box. See Fig. 3.
• Unit must be powered OFF to effectively
change their status.
Dip Switches
Configurations
DIP SWITCHES CONFIGURATIONS
See Table 1 and Fig. 4 for Dip Switches configurations and functions of each dip
switch position.
- Pull out at the bottom to release it
from the tabs 1.
- Then lift up 2.
Fig. 2
Fig. 3
Dip switches
Fig. 4
1 2 3 4 1 2 3 4
S1
S2 S3 S4 S5
S6
S7 S8
S9
X
A0-
A3
1 2 1 2 3 4
UP (ON)
DOWN (OFF)
Wall thermostat type
Heating type
Temperature display type
Control type
Setpoint limit 1
Setpoint limit 2
Fan CON/CYC for heating
Fan CON/CYC for cooling
Low temp. protection
NOTE
When making changes to dip switch settings, the power to the unit must be reset
for changes to take effect.