Use And Care Manual

 Page 17 
Installation
Instructions
Fig. 11
Fig. 12
Fig. 8
1
2
Fig. 9
Shipping
screw
• Remove the front panel. (see Fig. 8)
• Remove the shipping screw from the
vent door - only if ventilation is
desired.(s
ee Fig. 9)
• Rotate the vent control lever to either
open or close the vent door. (see Fig. 10)
• Lift
unit level and slide unit into wall
sleeve until firmly against front of
wall sleeve and secure with 4 screws
and washers (supplied in the SLEEVE
ASSEMBLY) through the unit flange
holes. (see Fig. 11 and Fig. 12).
• Reins
tall front panel. (see Fig. 13)
• Place tabs over top rail 1. Push
Inward at bottom until panel snaps
into place 2.
CAUTION
• Do not put obstacles around the
air inlet or inside of air outlet of
the unit, such as window curtains,
etc.
• Always insert the filters securely,
and clean filters every two weeks.
NOTE
When vent control lever is set to
CLOSE, only the air inside the room is
circulated and filtered.
When set to OPEN, some outdoor air
will be drawn into the room. This will
reduce heating or cooling efficiency.
Fig. 10
Vent control
Vent open
Vent closed
Fig. 13
1
2