Use And Care Manual

 Page 6 
Safety
Precautions
NOTE
The power supply cord with this
air conditioner contains a current
detection device designed to reduce
the risk of fire.
Please refer to the section Operation of
Current Device for details.
In the event that the power supply cord
is damaged, it can not be repaired. It
must be replaced with a cord from the
manufacturer.
WARNING - For your safety
• Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
• Avoid fire hazard or electric shock.
Do not use an extension cord or an
adaptor plug. Do not remove any
prongs from the power cord.
WARNING - Electrical Information
Be sure the electrical service is
adequate for the model you have
chosen. This information can be found
on the serial plate, which is located
on the side of the cabinet and behind
the grille.
• Be sure the air conditioner is
properly grounded. To minimize
shock and fire hazards, proper
grounding is important. The power
cord is equipped with a three-prong
grounding plug for protection
against shock hazards.
• Your air conditioner must be
used in a properly grounded wall
receptacle. If the wall receptacle
you intend to use is not adequately
grounded or protected by a time
delay fuse or circuit breaker, have
a qualified electrician install the
proper receptacle.
• Ensure the receptacle is accessible
after the unit installation.
• Do not run outside of wall sleeve or
with front grille removed. This could
result in mechanical damage within
the air conditioner or personal injury.
Grounding type wall receptacle
Power supply cord with 3-prong
grounding plug and current
detection device
Do not, under any
circumstances, cut,
remove or bypass
the grounding prong.