User Manual

Type-C female socket are used to provide work voltage for XY-MUP.
2>.Measuring voltage : ‘V’ and ‘COM’ terminals are used to measure Measured
Device Voltage.
3>.Measuring current : ‘A’ and ‘COM’ terminals are used to measure Measured
Device Current.
4>.There is a symbol ‘IN’ when work in PER mode.
5>.Short press button ‘ON/OFF’ to switch display current temperature or
Measured Device Voltage.
6>.Keep press button ‘ON/OFF’ for 5 second to turn ON or OFF display screen
backlight.But the module can output voltage normally.
7>.Keep press button ‘ON/OFF’ for 10 second to turn switch work mode PER or
VAH.
8>.Short press button ‘UP’ and ‘DOWN’ to switch display Measured Device Power
and current.And also can measure Battery capacity,Battery discharging time if connect
battery.
9>.The module does not support reverse connection protection, please do not
short circuit and reverse.
7.Calibrate Voltage/Current:
1>.Calibrate Voltage:Keep press button ‘ON/OFF’ before power ON and then
power ON and release button after 5 second.Automatically enter calibration mode.The
voltage display will flashing.Short press button ‘UP’ and ‘DOWN’ to adjust and
calibration voltage.Enter current calibration mode if keep press button for 2
second.Automatically save parameters and return to the normal display interface if
keep press button for 5 second.
2>.Calibrate Current:Enter current calibration mode if keep press button for 2
second after Calibrate Voltage.The current display will flashing.Short press button ‘UP’
and ‘DOWN’ to adjust and calibration current.Automatically save parameters and
return to the normal display interface if keep press button for 5 second.
3>.Voltage and current need to be separately calibrated separately in different
work modes. The same way of calibration.
8.Use steps:
1>.Connect to power supply from input terminal;
2>.Set work mode by keep press button ‘ON/OFF’ for 10second;
3>.Connect load or Device Voltage;
4>.Set required parameters;
5>.Test and use.
9.Application:
1>.Ordinary low power supply;
2>.Voltmeter;
3>.Ammeter;
4>.Battery capacity tester;