Sander User Manual

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio upstream frequency

105

Cisco IOS Release 12.1(5)XM

radio upstream frequency

To specify the upstream radio frequency, use the radio upstream frequency command. To disable this

function, use the no form of this command.

radio upstream frequency [freq] width [width]

no radio upstream frequency

Syntax Description

Defaults The default bandwidth will depend on the band that your multipoint system uses.

Command Modes Interface configuration

Command History

Usage Guidelines The radio interface cannot be enabled unless a center frequency is specified. Specify the center

frequency and the badwidth for the whole upstream channel group. The following is a pictorial

representation of the center frequency:

Examples The following example shows how to set the upstream center frequency for the radio mode in slot 6,

port 0:

UBR(config-if)# interface radio 6/0 radio upstream 0 frequency 5700000

freq The frequency in kHz (dBs are allowed). Valid range is 0 to 50000000 kHz.

width The keyword used for specifying the bandwidth.

width The bandwidth in MHz. The width must be supported by the RF/IF

modules.

Release Modification

12.1(3)XQ1 This command was introduced.

freq

width

35542

45 67