Sander User Manual

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
show interface radio snap-data
135
Cisco IOS Release 12.1(5)XM
show interface radio snap-data
To display the data captured for the snapshot specification, use the show interface radio snap-data
privileged EXEC command.
show interface radio slot/port snap-data dspNum snapshotType
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
slot/port The slot and port address.
dspNum The digital signal process (DSP) number (dsprx0, dsprx1, dsprx2, or
dsprx3).
snapshotType Specifies the snapshot type. User can specify the bitwise OR value of
as many as four of the following values in hexdecimal:
0x1—raw burst data received from a subscriber through antenna 1
0x2—raw burst data received from a subscriber through antenna 2
0x4—frequency spectrum received from antenna 1
0x8—frequency spectrum received from antenna 2
0x10—channel inpulse response for antenna 1 (what the physical chan-
nel looks like between the headend and the subscriber end)
0x20—channel inpulse response for antenna 2 (what the physical chan-
nel looks like between the headend and the subscriber end)
0x40—frequency domain of the channel-inpulse response for antenna 1
(for a group of subscriber units on an upstream channel)
0x80—frequecy domain of the channel-inpulse response for antenna 2
(for a group of subscriber units on an upstream channel)
0x100—frequency domain of the channel-inpulse response for antenna 1
(for a specific subscriber ID)
0x200—frequency domain channel-inpulse response for antenna 2 (for a
specific subscriber ID)
0x400—Codec data
0x800—interference estimate for antenna 1
0x1000—interference estimate for antenna 2
0x200000—TSID power array for power data burst or received power
wavelength for the up synchronization process. Shows a snapshot of sub-
scribers on an ALC window.
0x400000—correlation of power vector and power mask of the upstream
ranging signal (power for initial ranging)
0x800000—initial ranging time domain channel for antenna 1
0x1000000—initial ranging time domain channel for antenna 2
0x2000000— initial ranging time domain channel for antenna 1 and
antenna 2 combined
0x4000000—ranging smoothed time domain channel power