Sander User Manual

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio downstream rate-limit
42
Cisco IOS Release 12.1(5)XM
radio downstream rate-limit
To enable downstream rate limiting for downstream traffic, use the radio downstream rate-limit
interface configuration mode command. To disable rate limiting on downstream traffic, use the no form
of this command.
radio downstream rate-limit [token-bucket [shaping] | weighted-discard exp-weight]
no radio downstream rate-limit
Syntax Description
Defaults Rate-limit is enabled by default.
Command Modes Interface configuration
Command History
Examples The following example shows how to use the token bucket filter algorithm:
Router(config-if)# radio downstream rate-limit token-bucket
Usage Guidelines Cisco recommends that you keep the default setting of radio downstream rate-limit in order to use the
shaping option.
Related Commands
token-bucket (Optional) Specifies the token bucket filter algorithm.
shaping Enables shaping with default parameters. To change the defaults, you can
specify granularity (which is the traffic-shaping granularity in msec), or
you can specify max-delay (which is the maximum traffic-shaping buffering
delay in msec).
weighted-discard (Optional) Specifies the weighted discard algorithm.
exp-weight Specifies the weight for the exponential moving average of the loss rate.
Valid values are 1 to 4.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
radio upstream
rate-limit
Enables rate limiting for an upstream port on an upstream channel.