Sander User Manual

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio interface radio hist-clear
56
Cisco IOS Release 12.1(5)XM
radio interface radio hist-clear
To clear historgram data, use the radio interface radio hist-clear EXEC command.
radio interface radio slot/port hist-clear statsParams {MAC-address | chan-id}
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Examples The following example shows how to clear the histogram data for sinr-ant1 on channel 0:
Router# radio int r6/0 hist-clear sinr-ant1 0
slot/port Specifies the slot and port numbers.
statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1 |
rf-rx-power-ant2 | chan-delay-spread-ant1 | chan-delay-spread-ant2 |
power-amb}
sinr-ant1 Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2 Signal-to-interference plus noise ratio for antenna 2.
sinr-total Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain is not
included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna gain is
not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies a particular subscriber unit.
chan-id Specifies an upstream channel ID. Valid values are 0 to 3.
Release Modification
12.1(3)XQ1 This command was introduced.