Installation Guide

6
Tighten the
compression nut with
an adjustable wrench
unl snug. Aer the
radiator is lled and
heated, verify ALL
ngs are ght and
no water leaks.
9. 1/2” Copper Pipe Connecons - Bag F
Note: These instrucons show how to install supply / return piping from the oor. For alternate installaon
opons, see the full installaon manual. Bring rough piping up about 1 1/2” from the reducer ng on the
boom of the radiator.
Slide the large nickel
compression nut over
the pipe with the
open thread end
facing up.
Slide the copper split
compression ring over
the pipe with the
rubber poron facing
up. Unl it is fully
engaged with the
copper pipe.
Slide the pipe up unl
the rubber
compression ng
completely engages
with the reducer.
Slide the
compression nut up
the pipe and thread
it onto the reducer
by turning it
clockwise.
Slide the large nickel
compression nut over
the pipe with the
open thread end
facing up. Slide the
split compression ring
over the pipe.
8. 1/2” Pex Pipe Connecons - Bag E
Note: These instrucons show how to install supply / return piping from the oor. For alternate installaon
opons, see the full installaon manual. Bring rough piping up about 1 1/2” from the reducer ng on the
boom of the radiator.
Tighten the
compression nut
with an adjustable
wrench unl snug.
Aer radiator is lled
and heated, verify
ALL ngs are ght
and no water leaks.
Insert the barbed
compression ng
into the pipe unl
the shoulder rests on
the end of the pipe.
Slide the pipe up unl
the compression
ng completely
engages with the
reducer.
Slide the
compression nut up
the pipe and thread
it onto the reducer
by turning it
clockwise.