Operation Manual

PENTAGRAM Cerberus [P 6367]
Reset OOB: Press this button, the WPS client will be in idle state, and WPS indicator will turn off.
AP will not respond to the WPS client’s connection requests.
WDS Settings
Wireless AP signal coverage has range limits. WDS is mainly used to repeat wireless signal, and
enlarge its coverage. Please keep SSID, channel and encryption type of all AP respectively
consistent.
This router supports three WDS modes: Lazy, Bridge, Repeater.
• Lazy: In this mode, the connected router must be in Bridge or Repeater mode and the MAC
address of your router must be entered.
• Bridge: In this mode, the connected router must be in Lazy or Repeater mode. Manually add
the MAC address of the connected router to AP MAC address list or scan to select.
• Repeater: In this mode, the connected router can be in Lazy, Bridge mode or single client.
Manually add the MAC address of the connected router to AP MAC address list or scan to
select.
Access Control
To secure your wireless LAN, the wireless access control is actually based on the MAC address
management to allow or block the specific clients to access the wireless network.
MAC Address Filter:
• Allow: to only allow the clients in the list to access the wireless network.
• Block: to only prevent the clients in the list from accessing the wireless network.
MAC Address Management: Input the MAC addresses of the wireless clients you want to allow or
32