Operation Manual

horNET P 6121-L3 / P 6122-11
WPA/WPA2 Passphrase (Pre-Shared Key): Select this option and then click Configure… to
enter the authentication key used by the wireless network.
802.1x: Select this option and then select the EAP authentication protocol used by the network
from the 802.1x list. Click Configure… to set up the protocol.
Pre-Shared Key (Static WEP): Select this option and then click Configure… to enter the
authentication key(s) used to secure the wireless network.
None: Select this option when connecting to an insecure wireless network.
Profile Management window, Advanced tab
This tab contains advanced connection settings for the profile.
Power Save Mode: Select the power saving mode.
Network Type: Select the wireless network type.
802.11b Preamble: Select the preamble for connection to 802.11b networks.
Wireless Mode: Set up additional connection parameters:
• 2.4 GHz 54 Mbps: Select this for a 54 Mbps connection.
• 2.4 GHz 11 Mbps: Select this for a 11 Mbps connection.
• Super G: Select this to use Super G for the connection.
• eXtended Range (XR)™: Select this to use eXtended Range for the connection.
• QoS: Select this to use QoS settings for the connection.
Wireless Mode When Starting Ad Hoc Network: Set up additional connection parameters
when establishing an ad-hoc network:
• 2.4 GHz 54 Mbps / 2.4 GHz 11 Mbps: Select the speed at which the ad-hoc network will
operate.
• Channel: Select the channel on which the ad-hoc network will operate.
802.11 Authentication Method: Configure the authentication method for an ad-hoc
connection:
• Automatic: Select this for automatic configuration.
• Open System: Select this for an insecure network.
• Shared Key: Select this to use a security key.
Preferred APs…: Click to select access points (based on MAC addresses) to which the card
will attempt to connect as a priority.