User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

Installing batteries (Continued)

2. Load the four batteries into the battery compartment. Orient the positive polarity end of each battery

as shown below.

3. Install the battery cover and secure with the six screws. Make sure that the battery cover is secure

and that all the screws are tightened.

4. Power up the unit: To switch the unit on, press the Power On button located on the front of the

unit.

5. Display messages after replacing batteries: After replacing depleted batteries a check battery

message is displayed on the screen. Press the MENU/SELECT button to continue.

6. The screen will then display a second message to check the battery cover. After checking that the

battery cover is secure and that all screws are tightened, press the MENU/SELECT button.

The battery icon should display the fully charged icon ( ). The unit is ready for use.

(+) positive polarity

Secure battery cover

with the six screws

Easy Touch Control Panel (rear view)

Battery cover