User's Manual

9
EasyTouch Wireless Control Panel User’s and Installation Guide
Switching Power On
Use the POWER ON button located on the front of the EasyTouch wireless control panel to power up the
unit. Each time after batteries are installed in the unit, after powering up, a check message prompt is displayed.
Press the Up button to continue to display the main status screen. The unit is ready for operation.
Quick Start Spa and Pool Operations
The following describes how to run some of the general day-to-day spa and pool operations.
Heat your spa or pool
First enable the heat source in the Heat menu (see “Heat Menu,” on page 18). Press
the Spa button (top button) to switch the filter pump on, rotate the valve actuator (to
isolate spa water from pool water), and switch the heater on. Note: By default, the
setting “Man Heat’ is set to “On” (see page 35) which allows the spa to begin to
heat whenever it is manually turned on. Press the Pool button to switch the filter
pump on, rotate the valve actuator (to isolate pool water from spa water), and switch
the heater on. For Pool and Spa button location, see page 5.
Adjust your spa or pool heat settings
From the “Heat” menu (Menu/Select > Heat > Spa Temp/Src/Pool Temp/Src) you can select the heat
source and set the water temperature. The spa or pool water will heat to the settings specified. The
EasyTouch system allows for solar and conventional heaters. The EasyTouch will use the heating source that
is selected. The heat source selections are:
•
OFF - No heating even though pump and other circuits may be operating.
• HEATER - Gas heater only.
• SOLAR ONLY - Solar heating system to be the only heat source. In order to display “Solar Only” as a
heat option in the “Heat” menu, you must first enable solar in the Settings > Solar menu
(see page 31).
• SOLAR PREF. (Solar Preferred) - Used if solar and gas heating are combined and you want to use
solar heating only when it is most effective. In order to display “Solar Preferred” as a heat option in
the “Heat” menu, you must first enable solar in the Settings > Solar menu (see page 31).
To set the spa temperature set point and select the heat source:
Right button: Select spa temperature and heat source.
Up/Down button: Adjust the spa water temperature.
(from 40° F to 106° F or 4° C to 41° C).
Right or Left button: Move to Heat source options.
Up/Down: Set the Heat option: Off, Heater, Solar, or Solar Preferred.
Menu/Select: Press this button save settings and to return to the Heat menu or press
the button again to return to the Main screen.
Note: Select “Pool Temp/Src” to adjust your pool temperature.
Pool Temp/Src
Spa Temp/Src
X
T
S
Spa
Temp: 85° F
Heat: Off
T
S
Getting There
▼ HEAT
AUTO HEATER
SPA 95°F / 100°F
AIR 70°F
MON 09:30 AM