User's Manual

26
EasyTouch Wireless Control Panel User’s and Installation Guide
Settings Menu: Circuit Names
Labeling Circuit Buttons on the Wireless Control Panel
EasyTouch is shipped from the factory with each output circuit identified with its generic name (e.g. AUX 1,
AUX 2, etc.). These generic circuit auxiliary names can be assigned a new names which are more descriptive
of the equipment being controlled. This makes it much easier to operate all of the equipment on your pool
without having to memorize what each output controls.
Circuit name labels are also provided to be placed on top of each auxiliary control panel button. Use the
written list of circuit names (buttons) you made while setting up the EasyTouch load center. Identify what you
labeled circuit button 1, button 2 etc. The circuit names you assign should match the labels you put next to the
control panel buttons and the outdoor control panel buttons. Note that examples shown below use the factory
set generic output names. Note that examples shown use the factory set generic output names
(AUX 1), for your system you should change these generic names.
Circuit Names
To assign circuit names:
Up/Down buttons: Select the circuit number 1 of 9 (1/9). The generic circuits
names: Spa, Pool AUX 1 - AUX 7 (9 circuit names), Spa, Pool, AUX 1 - AUX 7
(EasyTouch 8) and AUX 1- AUX 3 (EasyTouch 4) each correspond to its assigned
circuit number.
Right button: Move to EasyTouch preset circuit names and user defined custom
circuit names.
Up/Down buttons: Scroll through the list of alphabetical programmed names. If you
cannot find a name to match your circuit, you can create your own custom name (see
page 30). Repeat for all the circuit buttons that you wish to assign names to. For a
complete list of EasyTouch circuit names, see page 27.
Menu/Select: Press this button to save settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Note: After a generic circuit name is changed and saved, the new name is
displayed in the menu settings. You can view the default generic circuit names in
the menu settings before they were changed by enabling “Cir Names.” Refer to
“Diagnostics: Cir Names (Off),” on page 40.
Hi-Temp/Lo-Temp Controls for Single Body System
For an EasyTouch single body system, you have the option to control your pool and spa temperature settings
using the Spa (Hi-Temp) and Pool (Lo-Temp) button on the Wireless control panel. Change the circuit name
SPA to HI-TEMP and POOL to LO-TEMP so that the display shows the correct temperature controls for your
single body system.
▼ SETTINGS ▼ CIRCUIT NAMES CIR NAMES
Getting There
▲
Circuit Names
Circuit #: 1/9
Circuit : Spa
[SPA ]
T
S