User's Manual

33
EasyTouch Wireless Control Panel User’s and Installation Guide
Settings Menu: F° / C° (Fahrenheit/Celsius)
The temperature settings for the water, solar and air can be displayed in either Fahrenheit or Celsius.
F° / C°
To change the temperature units:
Up/Down buttons: Select either Fahrenheit or Celsius.
Menu/Select: Press this button to save settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Settings Menu: iS4 Spa-Side Remote Controller
You can specify any iS4 Spa-Side remote button to control different functions by assigning each button to a
specific circuit. For example, you can use the iS4 Spa-Side remote to activate the spa circulation, and for
operating three auxiliary pieces of equipment (such as heat enabled, lights, jet pump, heat boost, air blower,
waterfall, etc.).
Assign iS4
Before configuring the iS4 Spa-Side remote controller assign names to the circuits (see page 26).
To assign iS4 Spa-Side buttons:
Up/Down buttons: Select a circuit to one of the iS4 buttons. You can set up to four
circuits (1/4, 2/4, 3/4, 4/4).
Right button: Move to the circuit setting.
Up/Down buttons: To configure the first button on the iS4 Spa-Side Remote, scroll
through the circuit names and find the circuit that you would like to assign to the first
button on the iS4. The circuits selections are: None, Spa, Pool, Aux 1-7, Heat Boost,
Heat Enable, (EasyTouch 8). None, Spa, Pool, Aux 1-3, Heat Boost, Heat Enable
(EasyTouch 4). Note that “None” does not assign a circuit. Note: The “Heat Boost”
feature will switch on the heater for seven minutes to increase the spa water
temperature. Each time the spa Heat Boost button is pressed, the temperature will
increase about 1
° F. The temperature will not go beyond the 106° F limit.
Right button: Assign the next circuit (2/4).
Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4) and
repeat the procedure for the other three buttons.
Menu/Select: Press this button to save settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Note: To disable or enable the iS4 Spa-Side remote, see Settings Menu: Spa Side,” on page 37.
▼ SETTINGS ▼ IS4 ASSIGN iS4
Getting There
▲
T
F° / C°
FAHRENHEIT
S
▼ SETTINGS ▼ F˚ / C˚ F˚ / C˚
Getting There
▲
T
Assign iS4 1/4
Circuit:
[HEAT BOOST ]
S