User's Manual

38
EasyTouch Wireless Control Panel User’s and Installation Guide
Diagnostics Menu: Software Rev
Displays the current software revision for the EasyTouch main control panel and the wireless control panel.
UIC: Displays the current software revision level for the wireless or indoor control
panel.
UOC: Displays the current software revision level for the outdoor control panel.
Menu/Select: Press this button to return to the Settings menu options. Press the
button again to return to the main menu options or press again to return to the Main
screen.
Diagnostics Menu: Bootloader Rev
Displays the current bootloader revision for the wireless control panel and the EasyTouch outdoor control
panel.
UIC: Displays the current bootloader revision level for the wireless or indoor control
panel.
UOC: Displays the current bootloader revision level for the outdoor control panel.
Menu/Select: Press this button to return to the Settings menu options. Press the
button again to return to the main menu options or press again to return to the Main
screen.
Diagnostics Menu: Self Test
Tests the control panel LCD and buttons. Follow the on-screen prompts to perform the tests.
Note: If the Indoor Control Panel is connected to the EasyTouch outdoor control panel, select “LINK
CLOSED” in the UART test to abort the UART test. This allows the test to complete with PASSED.
Press the Right button to display the current software and bootloader revision levels
for the Indoor Control Panel.
Press the Right button to start the test:
Display Test: Press any button to start the LCD test.
Backlight Test: Press the Left then Right button.
Contrast Test III: Press any button to continue.
LED Test: Press any button to continue. All of the button LEDs will be tested.
Switch Test: Press any button to continue. As prompted, press the appropriate
buttons.
UART Test: Select “LINK CLOSED” to abort this test if the optional Indoor
Control Panel is connected to the EasyTouch load center.
Status: Passed - Code: None After you have completed the test an error code is
displayed. If the test was successful, “Passed” is displayed. For error code
descriptions, see “Self Test Error Codes,” on page 44.
Menu/Select: Press this button to return to the Settings menu options. Press the
button again to return to the main menu options or press again to return to the Main
screen.
▼ DIAGNOSTICS ▼ SOFTWARE REV
Getting There
▼ DIAGNOSTICS ▼ BOOTLOADER REV
Getting There
▼ DIAGNOSTICS ▼ SELF TEST
Getting There
Bootloader Rev
UIC: 1.000
UOC: 1.000
Software Rev
UIC: 1.000
UOC: 1.000
Backlight On
<=Backlight On
>=Backlight Off
Contrast: III
Press any button
LED Test
Switch Test
Press any button
UART Test
<=Link Closed
>=Link Open
Press Any Button