User's Manual

44
EasyTouch Wireless Control Panel User’s and Installation Guide
egasseMrorrEesuaCelbissoPnoituloS
niaMehtnosyalpsiD(rrEriA
)neercS
detcennoctonrosnesriA
hcuoTysaEehtot
.dra
obrehtom
12JotdetcennocsigulprosnesriaehttahtkcehC
rosnesehttahtkcehC.draobrehtomehtnorotcennoc
.ylreporpdetcennocsieriw
nisyalpsiD(rrEerutarepmeTriA
)unem"scitsongaiD"eht
detcennoctonrosnesriA
hcuoTysaEehtot
.
draobrehtom
12JotdetcennocsigulprosnesriaehttahtkcehC
.draobrehtomehtnorotcennoc
syalpsiD(rrEerutarepmeT
retaW
)unem"scitsongaiD"ehtni
tonrosnesretaW
ehtotdetcennoc
.draobrehtomhcuoTysaE
12JotdetcennocsigulprosnesretawehttahtkcehC
.draobrehtomehtnorotcennoc
syalpsiD(rrEerutarepmeTraloS
)unem"scitsongaiD"ehtni
tonro
snesraloS
ehtotdetcennoc
.draobrehtomhcuoTysaE
12JotdetcennocsigulprosnesralosehttahtkcehC
.draobrehtomeh
tnorotcennoc
edoCrorrEnoitpircseD
0edoClenaplortnocehT-SSAP
smelborponsah
1edoCthgilkcabDCL
2edoCtsartnocDCL
3edoCsDEL
4edoC)s
nottub(hctiwS
5edoCtsetkcabpoolTRAU
EasyTouch Error Messages
Error Messages
If the system detects that a sensor is not connected to the EasyTouch load center or it is defective, an error
message is displayed in the “Diagnostics” menu. The following lists the sensor errors.
Self Test Error Codes
The “Self Test” feature is intended for use by service personnel. If after performing a control panel self test
(see page 38) there were no errors detected, Code 0 is displayed, indicating that there were no problems and
the test was successful. If a problem is detected during the test, an error code is displayed upon completion of
the test. For example Code 3 would indicate a problem with the LEDs on the control panel. If multiple errors
are detected, multiple code numbers are displayed. For example, Codes 4, 2, 1, would indicate problems
detected with the buttons, LEDs, and the LCD backlight on the control panel.
The following lists the control panel self test error codes.
Error Code Table