User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

6. Position the back plate over the mounting points and secure it with the four mounting screws

(provided in the kit).

7. Carefully slide the transceiver circuit board into the back plate.

8. Strip the leads of the communication cable wires back ¼ in. Insert the wires into the connector screw

terminals (provided in the kit). Using a small flat-blade screwdriver, secure the wires with the

terminal screws. Make sure to match the color-coding of the wires: GND = Black, Green = -DT,

Yellow = +DT, and Red = +15. Connect the screw terminal connector onto the transceiver circuit

board.

9. Slide the case over the back plate. Secure the case to the back plate using the two retaining screws.

10. Proceed with “Connecting the EasyTouch Transceiver EasyTouch Load Center,” on page 51.

Transceiver Module

Screw terminals

Back plate

Retaining screws

Transceiver Circuit Board

Case

Knockout hole

Antenna

Mounting point (4x)

1DNGKLB

2TD-NRG

3TD+LEY

4V51DER