User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

COM PORT

(J20)

Indoor Control Panel

IntelliChlor

IntelliFlo

RF Transceiver

EasyTouch Motherboard

2. At the EasyTouch load center, route the four conductor transceiver connection cable into the lower

plastic grommet, up through the low voltage raceway to the motherboard.

3. Strip back the cable conductors ¼ inch. Insert the wires into the screw terminals (provided in the

Personality Kit). Secure the wires with the screws. Make sure to match the color-coding of the

wires: GND = Black, Green = -DT, Yellow = +DT, and Red = +15

4. Insert the screw terminal connector onto the COM-PORT (J20) connector on the motherboard.

Note: Multiple wires may be inserted into a single screw terminal.

5. After the connection has been completed, close the control panel into its original position and secure

it with the two access screws.

6. Install the front panel and secure it with the two retaining screws.

7. Close the EasyTouch load center front door. Fasten the two spring latches.

8. Switch the power on to the EasyTouch load center.

Raceway

Control panel

Motherboard