User's Manual

IntelliCenter Control System Wireless Control Panel Installation Guide
IntellliCenter Control System Wireless Control Panel Installation Guide
5
6. Position the back plate over the mounting points and secure it with the four mounting screws
(provided in the kit).
7. Carefully slide the transceiver circuit board into the back plate.
8. Strip the leads of the communication cable wires back ¼ in. Insert the wires into the connector
screw terminals (provided in the kit). Using a small flat-blade screwdriver, secure the wires with
the terminal screws. Make sure to match the color-coding of the wires: GND = Black, Green = -DT,
Yellow = +DT, and Red = +15. Connect the screw terminal connector onto the transceiver circuit
board.
9. Slide the case over the back plate. Secure the case to the back plate using the two retaining screws.
10. Proceed to “Connecting the Transceiver to the IntelliCenter Control System Load Center,” on
the next page.
Transceiver Module
Back plate
Retaining screws
Transceiver
circuit board
Case
Knockout hole
Antenna
Mounting point (4x)
Screw terminals
1 GND BLK
2 - DT GRN
3 + DT YEL
4 15V RED
Mounting the Transceiver (Continued)