User's Manual

QuickTouch
®
II Wireless Remote Installation and User’s Guide
13
Installing the Receiver
The QuickTouch II wireless remote has an operating range of up to 500 ft.
(line-of-sight) from the receiver.
To install the receiver:
1. Choose an installation location for the receiver near the load center.
2. Remove the two lower retaining screws from the receiver and slide the
receiver case up to remove it from the back plate.
3. Remove the receiver circuit board from the back plate by carefully
lifting it up out of the back plate supports. Place the circuit board on a
clean dry surface away from direct sunlight.
4. Mount the receiver back plate (see page 9) onto a flat wooden surface,
such as a wooden fence, or post. While holding the back plate, install
two lower mounting screws through the back plate lower mounting
holes. Tighten the screws to secure the back plate in place. Install two
screws through the upper mounting holes.
5. Slide the receiver circuit board into the back plate into the board side
supports.
6. Route the receiver cable up through the bottom of the back plate (see
page 9) to the screw terminal connector.
7. Insert the four wires into the screw terminals of the receiver connector.
Using a small flat-blade screwdriver, secure the wires with the screws.
Make sure to match the color coding of the four wires (see page 12 for
wiring diagram).
8. Carefully slide the case over the receiver antenna and secure it to the
back plate with the two lower retaining screws.
9. Proceed with “Connecting the Receiver cable to the IntelliTouch
Personality board” on page 10.