User's Manual

QuickTouch
®
II Wireless Remote Installation and User’s Guide
16
Connecting the Transceiver cable plug to the Serial Com Port Expansion
Board
Connect the Transceiver cable plug onto one of the available Serial COM port
expansion board connector terminals.
Note: If you have existing accessories (IntelliChlor, IntelliFlo) connected to the
IntelliTouch Personality board and need to free up connectors for additional
equipment, remove one of the existing connectors (with the attached wires to
equipment) from the Personality board and plug it into an available connector
on the Expansion board COM port (as shown below).
Cables to
accessories
(IntelliChlor,
Indoor
Control
Panel etc.)
Low
voltage
compart-
ment
Expansion
board
adhesive
backed
supports
(x4)
Connect existing
accessory connec-
tors wires here
Connect to COM port
on IntelliTouch Per-
sonality board
Connector from the Expansion
board
Connect IntelliFlo
wires to two-pin
terminal connector