User's Manual

QuickTouch

II Wireless Remote Installation and User’s Guide

Connecting the spa-side remote to a CP3xxx load center using

adapter

Strip back the cable 1-inch and ends of leads ¼-inch. Open the cable adapter (P/N

520000, included in kit). Insert the spa-side remote cable into the adapter and attach

wires to the terminals (see the wiring diagram below). Attach the six conductor flat cable

pig-tail between cable adapter and the COM port connector on the circuit board in the

Compool load center.

Upgrading from the Compool SS8 to the Spa-Side Remote

The spa-side remote may be used to replace the SS8 spa-side remote on the CP3xxx

family of systems. Note: The spa-side remote can still only control up to eight functions.

Note: The SS8 must also have been plumbed with a minimum 1-inch conduit.

Remove SS8 Remote

Unplug the SS8 from the load center then pull out the unit from spa-side location.

Remove the SS8 mounting bracket from spa-side location (two screws). All that should

be left is a minimum of 1-inch. diameter conduit.

Install the Spa-Side Remote

For spa-side remote installation instructions, see page 8-9).

Controller Adapter

RED YEL

YEL RED

GRN GRN

BLK WHT

WIRING

Spa-Side Remote Wiring

Diagram

Compool connector block with cables

COMPOOL SS8 REMOTE UPGRADE INSTALLATION

SpaCommand Spa-Side Remote Replaceable Parts List