User's Manual

QuickTouch
®
II Wireless Remote Installation and User’s Guide
19
Changing the Battery
With normal use the battery should last for several years. In the event
the battery must be replaced, slide the coverfrom the bottom of the
Hand-held Remote. Slide the battery from the retainer clip and
discard in accordance withlocal and/or state ordinances. Replace
with 3V lithium battery number CR2032 or equivalent. Slide battery
coveronto remote and snap in place.
When you are not using the MobileTouch controller, place it in the
cradle to recharge the battery. This allows the battery to be fully
charged at all times.
To charge the MobileTouch controller battery
• Plug the AC adapter into an AC wall outlet.
• Insert the AC Adapter plug into the bottom of the cradle.
• Place the MobileTouch controller in the cradle.
Note: When the MobileTouch controller is placed in the cradle
the display and backlight will be on. After five minutes the
backlight will shut off. The MobileTouch unit and display are
always on when seated in the cradle. To turn the backlight on,
press any button.
To use the MobileTouch wireless controller
1. Remove the MobileTouch wireless controller from the
cradle. Note: With AC power connected to the cradle,
the MobileTouch controller can be used while seated
in the cradle.
2. Press the Power On/Off button (front lower right-side)
to switch the unit on. The main screen is displayed.
The LCD backlight will turn off in five minutes if not in
use. The battery icon displays three solid bars, only
when it’s fully charged. Note: If the MobileTouch is not
being used for extended periods of time, press the
Power On/Off switch to turn the controller Off.