User Manual

Rev X1 Pentair Pool Products, Inc. P/N 840316
Sanford NC
Moorpark CA
7. Make sure the receiver module will clear the body and the entire antenna remains
inside of the PG2000 housing.
8. Replace the PG2000 body
9. Switch power switch to RF2000 position. The colorwheel switch remains in the
off/RF2000 position.
10. Install the 9V battery in the transmitter.
Operating instructions
1. The 4 buttons along the top of the transmitter are the channel buttons. Depress the
appropriate channel you would like to operate. The channel button is activated if it is in
the depressed position. The default setting in all receivers in channel 1.
2. To turn on the unit press the “power on” function button. The beeping sound indicates
that a signal is being sent. Hold down the button until the unit turns on. This should
happen immediately but there may not be a visible indicator since the bulb must first
warm up. The transmitter will only send a signal for 5 seconds as indicated by the
beeping.
3. To turn on the colorwheel press the “color on” function button. The beeping sound
indicates that the signal is being sent. There is a 1/2 second delay once it has received the
signal.
4. To freeze on a color simply press the “color off” function button. If you turn the
power off, it will also shut off the colorwheel.
5. If the unit is cycled off then on it may take up to 3-4 minutes for the lamp to “restrike”
or come back on. All metal halide lamps have this characteristic and this is a normal
function of the PG2000.