User Guide

8
PROWLER® 920 and WARRIOR® SE Robotic Inground Pool Cleaner Installation and User’s Guide
Storing the Cleaner
Any time the cleaner will not be in use for an extended period of time, for example during the winter, follow the storage
recommendations below:
• Be sure to disconnect the power supply after use.
• Store the power supply, cable, and cleaner with the caddy if included with the cleaner.
• Store the cleaner in a protected area out of direct sun, rain and frost, at a temperature between 5°-45°C / 41°-113°F.
• Drain all water from the pool cleaner.
• Thoroughly clean the filter basket and filter screens and store the cleaner with them installed.
STEP 5:
Remount the Impeller Cover
Gently push the impeller cover back onto the impeller
assembly. See Figure 25.
The tabs on the motor unit will lock the cover into place.
Figure 25
STEP 6:
Remount the Intermediate Cover and Manifold
Assembly
Reseat the intermediate cover and manifold assembly and
reinstall the two screws that hold the cover and manifold
assembly in place. See Figure 26.
2
1
3
Figure 26