User Manual

ManualsBrandsPentair ManualsRemote ControlEasyTouch EZ3400

Rev. C 10-31-02 1 P/N 520044

Model EZ3400 EasyTouch Owner’s Manual

4-Function Hand-Held Wireless Remote Control

Important Notice

Attention Installer.

This manual contains important information about the installation, operation and safe use of this

product. This information should be given to the owner/operator of this equipment.

Before installing this product, read and follow all warning notices and instructions which are included.

Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.

Call (800) 831-7133 for additional free copies of these instructions.

WARNING

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151

10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400

WARNING

Risk of electrical shock or electrocution. If your Compool electrical panel includes circuit breakers

(almond colored steel enclosure), it is also required that the main power into the home be switched

off at the main circuit breaker box.

Table of Contents

SECTION I. APPLICATION ................................................................................................................................2

SECTION II. KIT CONTENTS ............................................................................................................................. 2

SECTION III. RECEIVER .................................................................................................................................... 2

SECTION IV. POWER CENTER .......................................................................................................................... 2

SECTION V. CABLE SPLITTERS (Optional) ...................................................................................................... 3

SECTION VI. HAND-HELD REMOTE ................................................................................................................... 3

SECTION VII. RECEIVER CIRCUIT BOARD ........................................................................................................ 3

SECTION VIII. RECONFIGURING FUNCTIONS ON THE HAND-HELD REMOTE ................................................. 4

SECTION IX. CUSTOMIZING THE COMMUNICATION LINK ............................................................................... 5

SECTION X. HAND-HELD REMOTE BATTERY REPLACEMENT ....................................................................... 5

TROUBLE-SHOOTING ................................................................................................................... 6

WARRANTY ................................................................................................................................... 7

Summary of content (8 pages)

PAGE 1
Model EZ3400 EasyTouch Owner’s Manual 4-Function Hand-Held Wireless Remote Control IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS Table of Contents SECTION I. APPLICATION ................................................................................................................................ 2 SECTION II. KIT CONTENTS ............................................................................................................................. 2 SECTION III.
PAGE 2
SECTION I. APPLICATION Used in conjunction with the following Compool Control Systems: CP3400, CP3600, CP3800, CP3810 and CP3830. Provides switching of four remote control circuits from a wireless hand-held remote. It is typically used for activating the spa circulation, and for operating three auxiliary pieces of equipment (such as lights, jet pump, air blower, waterfall, etc.). Each of the four functions on the hand-held remote has an "ON" and an “OFF” button. SECTION II. 1-qty. 1-qty. 4-qty. 4-qty.
PAGE 3
SECTION V. CABLE SPLITTERS (OPTIONAL) Most Power Center circuit boards include 2-qty. COM PORT sockets. However, if there is no unused COM PORT socket available, it will be necessary to use a Cable Splitter (P/N 6CONDDUAL). Disconnect the existing Indoor Remote cable from the COM PORT socket. Plug the short cable (attached to one end of Cable Splitter) into COM PORT socket. Plug existing Indoor Remote cable into one of the open sockets of the Cable Splitter.
PAGE 4
SECTION VIII. RECONFIGURING FUNCTIONS ON THE HAND-HELD REMOTE There are 4-qty 4-position configuration switches (designated SW1, SW2, SW3 and SW4) located on the Receiver circuit board. These switches are used to configure the four buttons on the Hand-held Remote: SW1 will configure Spa Button (of the Hand-held Remote). SW2 will configure “A” Button (of the Hand-held Remote). SW3 will configure “B” Button (of the Hand-held Remote). SW4 will configure “C” Button (of the Hand-held Remote).
PAGE 5
SECTION IX. CUSTOMIZING THE COMMUNICATION LINK The communication link between the Receiver and Hand-held Remote can be customized to prevent electrical interference. To accomplish this, there is a 10-position configuration switch located on the Receiver circuit board, and inside the Hand-held Remote. Units are shipped from the factory with all switches in the ON position.
PAGE 6
TROUBLE-SHOOTING Symptom Possible Cause Solution POWER LED does not light. LX Control Center does not have power. Insure power is being supplied and that the LX Control Center operates correctly without the receiver installed. Defective cable or connection to the LX Control Center. Verify the function of the board using known good cable set. Defective receiver board. Contact factory or service center. COM LINK LED does not light or blink. Defective cable or connection to the LX Control Center.
PAGE 7
Warranty Pentair Pool Products warrants to the original purchaser of this electronic control system, for the period of one year from the date of original purchase for use, that any defective product proved to be caused by faulty workmanship or faulty material, will be repaired or replaced at Pentair Pool Products’ option at no charge, providing the product is returned to Pentair Pool Products with all transportation charges prepaid.
PAGE 8
SAVE THESE INSTRUCTIONS. Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 P/N 520044 8 Rev.