LEGEND ® Pressure Side Pool Cleaner Installation Guide IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS LEGEND® PLATINUM INSTALLATION MANUAL
Customer Service If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support Sanford, North Carolina (8 A.M. to 5 P.M. — Eastern Time) Phone: (919) 566-8000 Fax: (919) 566-8920 Moorpark, California (8 A.M. to 5 P.M. — Pacific Time) Phone: (805) 553-5000 (Ext. 5591) Fax: (805) 553-5515 Web site visit www.pentairpool.
LEGEND ® LL105PM / LL105PMG LL105PMTGG / LL105PMTWW LL105PMTRW / LL105PMTYW Important Information: The Legend® Platinum automatic pool cleaner comes ready to connect into a female threaded 1-1/2" line, dedicated to our Universal Booster Pump. Also, if you have a chlorinator, solar system or other air inducing equipment, contact our Technical Support Department at 1-800-831-7133 before you install the Legend® Platinum. (See diagram on page 2).
TABLE OF CONTENTS I. Introduction ................................................................................................................................ 1 A. Thank You for Choosing the Legend® Platinum.................................................................. 1 B. What to Expect from the Legend® Platinum. ..................................................................... 1 II. Installation Instructions .....................................................................................
I. Introduction A. Thank You for Choosing the Legend® Platinum Pool Cleaner B. What to Expect from the Legend® Platinum Congratulations on the purchase of your new automatic pool cleaner. The Legend® Platinum is designed to give you years of dependable and efficient service. With the Legend® Platinum, you and your family will spend more time relaxing and enjoying your pool and less time cleaning it.
II. Installation Instructions A. Legend® Platinum Components B. Pool Connections The Legend® Platinum Box Contains: The Legend® Platinum comes equipped to connect to a female threaded 1-1/2 in. line, dedicated to our Universal Booster Pump. 1. 2. 3. 4. Cleaner Head Sand & Silt Bag Sweep Hose Complete Feed Hose a. 1 - 8½ in. hose b. 2 - 10 ft. long hoses c. 1 - 30 in. soft hose/1 - 7½ ft. soft hose d. 10 - Floats e. 3 - Swivels f. 1- Back-Up Valve g. 10 - Mender Nuts h.
D. Installing the Twist Lock Pressure Relief Valve (Wall Fitting) 1. Take out any existing pool cleaner and/or wall fitting. 2. Turn on the filtration pump and booster pump, flush out the plumbing line. 3. Turn off filter pump and booster pump. 4. Remove the Wall Adapter from the Wall Fitting and screw Adapter by hand into the dedicated line. Turn until tight. WALL ADAPTER INSTALLED QUICK DISCONNECT QUICK LOCK PEG O-RING 5.
EXAMPLE OF HOSE ASSEMBLY BEFORE CUTTING TO LENGTH STEPS 1. With the feed hose assembly attached to the pool wall, hold the feed hose assembly by the opposite end with the clear hose and walk the perimeter of the pool to locate the farthest point on the perimeter from the wall fitting without stretching the hose assembly. 2. Measure the distance that the hose assembly extends beyond the pool perimeter farthest point located in Step 1 — (7½ ft. in this example). 3.
E. Cutting the Feed Hose - (cont.) 3. Lay the telepole next to the clear (soft) hose. If the clear (soft) hose is longer than the mark on the telepole, cut the excess from the end attached to the white (hard) hose. Do not cut off the float. Leave the first float in position next to the Back-Up Valve. Place the second float midway between the first float and the Hose Swivel. 7. Re-assemble the hoses and the swivel using mender nuts (see Figure below, Step 1).
E. Cutting the Feed Hose - (cont.) 8. When cutting hoses, please use strong scissors or a sharp knife. Be sure to slide the floats out of the way when cutting hose. 9. Put extra mender nut on the Legend® Platinum mast and push soft hose gently over mast at 1/2 in., turn mender nut around soft hose tight. Note: The Back-Up Valve still should be 30 in. from the head of the cleaner. 12. Lower your complete Legend ® Platinum assembly into your pool carefully. It should look like figure below.
F. Checking Operation When operating correctly, the Legend® Platinum will travel in a random pattern throughout the pool, vacuuming and sweeping the bottom. The climbing ability of the Legend® Platinum is dependent on the pools structure and water flow coming into the pool. It will perform more efficiently in pools without sharp angles or curves in the transition from the floor of the pool to the wall. The Legend® Platinum comes with a Twist Lock Pressure Relief Valve (Wall Fitting).
3. Checking Wheel RPM To determine whether the Legend ® Platinum is receiving the proper water pressure, turn off the booster pump, pool pump and carefully remove the Legend® Platinum from the pool. Mark the front drive Tire/Wheel with a marker, or use the Logo located on the side of tire as a marker to count the rotations of the wheel per minute. Have someone turn on pool pump and then booster pump while you place the Legend ® Platinum in the pool just beneath the water surface.
III. Operation/Periodic Maintenance D. Periodic Maintenance A. The following parts are wear items that should be checked, maintained or replaced as needed. Wear items are considered any working or moving part(s) being worn due to the use of the cleaner. Wear items are not covered under warranty. Connecting/Disconnecting the Legend® Platinum Turn off booster pump and pool pump. Then take the Wall Fitting and twist lock the Wall Fitting clockwise into the Wall Adapter.
III. Operation/Periodic Maintenance (cont.) 5. Sweep Hose 2. Tires & Bearings The Sweep Hose is provided to help keep the bottom and sides of your pool clean. The Sweep Hose is warranted free of defects when shipped from the factory, and is considered a wear item. The tires are designed to protect the bottom of your pool and provide better traction. You need to rotate or replace the tires when edges become rounded. 6.
IV. TROUBLESHOOTING AND PERFORMANCE TIPS To insure the best performance from your cleaner, follow the troubleshooting guide listed below. A. PROBLEMS & SOLUTIONS Problem: Legend® Platinum doesn't move or moves sluggishly or hangs up on steps. Solution: 1. Be sure filter pump and booster pump are on and working properly. (You may need to clean your pool filter system). 2. Check the Wall Fitting screen for debris and rinse clean. 3. Check wheel RPM (See page 8). 4. Determine if the Back-Up Valve is cycling.
IV. TROUBLESHOOTING AND PERFORMANCE TIPS A. PROBLEMS & SOLUTIONS - (cont.) Problem: Sweep Hose is sucked into the cleaner. Solution: 1. Adjust the Sweep Hose using the Adjustment Screw located on the bottom of the Swivel Mast. Turn Adjustment Screw clockwise until the Sweep Hose is in a gentle sweeping motion. Problem: Sweep Hose breaks surface and sprays nearby windows, patio decks and bystanders. Solution: 1. Adjust Sweep Hose to a gentle sweeping motion. 2. Add optional Sweep Hose weight (See page 10).
LEGEND® PLATINUM PARTS LIST Diagram # 1 2 2 3 3 4 4 5 6 7 8 8 9 9 10 10 11 11 12 12 13 14 14 15 15 16 16 17 17 18 18 19 19 20 21 22 23 23 24 24 25 26 27 28 28 Part # Description LLU5PM LLU145N LLU145NG EU10N LLU10NG LLU6 LLU6G EC86 EC83 EC80 EA40 LLA40G EC110 LLC110PM EX120 LLX120 EC120 LLC120G EB5L LLB5G EB10 EB25 LLB25PM EB20 LLB20G EA20 LLA20PMG EH07 LLH07PM EU15 EU15G EU16 EU16G EU9 EU7 E18 EC130 LLC130G EC135 LLC135G EC65 EC70 EC45 LLC6PM LLC6PMG Top Cover - Gray Main Frame - White Main Frame - Gra
LEGEND® PLATINUM PARTS LIST Part # Description 29 30 30 31 31 32 32 33 34 35 35 36 36 37 37 38 38 39 39 40 40 41 41 41 41 42 43 43 44 45 46 LLC60PM E10 LL10PM EC55 LLC55PM LLC1PM LLC1PMG EB15 EC40 LLD50 LLD50PM ED10P LLD10PM LLD45 LLD45PM ED05 LLD05PM LLU1 LLU1PM ED15 LLD15PM LLW22PM EW22 LL25PM E25 E24 LL23PM E23 EC64 EG15 EC131 46 LLC131G 47 EU30 48 49 49 50 51 51 52 53 53 EU76 EU147 LLU147G EU79 EU80 LLU8G EU80 LLU81PM LLU81PMG Wheel Bearings Only - Gray Back-Up Valve - White Back-Up Valve - Gr
LEGEND® PLATINUM EXPLODED VIEW 8.5" 7.
5/31/06 P/N YYPLATINSTALL REV. C © Pentair Water Pool and Spa, Inc. All rights reserved. Printed in USA.