Pool Products Side Pool Cleaner MANUAL

LEGEND® PLATINUM INSTALLATION MANUAL
5
7. Re-assemble the hoses and the swivel using
mender nuts (see Figure below, Step 1). Put
mender nut on swivels first, then push hose over
swivel (see Figure below, Step 2). Rotate mender
nut over hose clockwise until tight. Note: Keep
as many floats as possible on the long feed
hoses, spaced evenly apart to hold hose up
on top of water.
FEED
HOSE
MENDER
NUT
BARB ON SWIVEL
OR LEGEND
STEP 1
STEP 2
STEP 3
PUSH HOSE OVER BARB
PUSH MENDER NUT TOWARD HOSE AND ROTATE
CLOCKWISE BY HAND UNTIL TIGHT
SMALL END
OF MENDER
NUT AWAY
FROM HOSE
E. Cutting the Feed Hose - (cont.)
3. Lay the telepole next to the clear (soft) hose. If
the clear (soft) hose is longer than the mark on
the telepole, cut the excess from the end attached
to the white (hard) hose. Do not cut off the float.
Leave the first float in position next to the
Back-Up Valve. Place the second float midway
between the first float and the Hose Swivel.
4. Attach feed hose to the wall fitting and attach to
the pool wall. Hold the end of the 30 in. clear (soft)
hose and walk the perimeter of the pool keeping
the hose straight (do not stretch hose) to find the
farthest point of the pool from the wall fitting.
5. Measure the excess length between the farthest
point of the pool from Wall Fitting and the end of
30 in. clear (soft) hose.
6. Half of this measured length to be cut equally
from the 10 ft. long hoses next to the Marked
Swivel. (Example: Half of 6 ft. = 3 ft. each). If you
are cutting more than 2 ft. off the hoses, remove
the floats next to the Marked Swivel from both
hoses. See Figures on page 4.
Water Level
White (Hard) Hoses
Swivel
Cut and Remove the
Excess Hose Length
Cut Clear (Soft) Hose Equal to
the Deepest Pool Water Level
Telepole / Clear (Soft) Hose