Instructions / Assembly

1. Level the Whole House Iron & Manganese Filter.
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands vertical. The bottom of the tank is
round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line from the Injection Pump and choose the appropriate ttings
required to connect it to the Bypass Valve.
Do not over-tighten any of the ttings during installation.
Note
CAUTION
• Ensure the PVC Tubing Backwash Drain Line is not submerged and is free of kinks.
• Maximum vertical rise of the backwash line is 6 feet.
• If incorporating two or more backwashing systems make sure to keep the drain lines
separate or install a one way check valve between the units.
IRON AND MANGANESE TANK INSTALLATION
IMPORTANT
www.pelicanwater.com
[phone]
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Drain Line
Barb
Outgoing
Water to
House
Electronic
Head
IN
OUT
Top View
Wall Wall
Incoming
Water
Supply
Sediment Filter
Chemical
Injector
Pump Tubing
Solution Tank
Chemical Injector
Pump
Whole House
Iron & Manganese Filter
Whole House
Water Filter
Spigot
Electronic Head
Red Clips
Tail Adaptors
Bypass Valve
Part Description Qty.
1" PVC Tail Adaptor for
Electronic Head Bypass
2
Top View
Front View
IN
OUT
Wall Wall
Incoming
Water
Supply
Sediment Filter
Whole House
Filter
Outgoing
Water to
House
Water to Home
Water
Softener
Alternative
Bypass
Solution
Tank
Water
Filter
Injection Pump
Iron
Manganese
Filter
Sediment Filter
Iron
Manganese
Filter
Water
Softener
Alternative
6
Drain Line Connection
Water Inlet
Water Outlet
3. Remove the white and red cap from the top of the Whole House Iron & Manganese tank.
4. Screw the Electronic Head onto the tank hand tight.
5. Install the ttings onto the inlet and outlet, following the labels on the Head.
6. Wrap 2-3 turns of Teon tape on the drain line connection hose barb. Screw into the drain port hand tight. Do not over tighten.
7. Connect the incoming water supply to the tting on the inlet side of the Bypass Valve.
8. Connect the outgoing water supply to the outlet side of the Bypass Valve.
9. Slide hose clamp over one end of drain tube drain line barb and secure to the hose barb
with the hose clamp. Secure the other end of the line to a drain. Note: An air gap
connection is required.
10 • IRON & MANGANESE FILTER SYSTEM COMBO