Instructions / Assembly

WHOLE HOUSE WATER FILTER INSTALLATION
2. Determine the size and material of your incoming water supply line and choose the appropriate plumbing required to adapt
to the 1” male NPT Assembly.
Visit Pentair.com to view our full line of installation kits.
CAUTION
1. Level the Whole House Water Filter.
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
Notice
Do not over-tighten any of the ttings during installation.
Note: The tting below is designed with a ¼" give to allow for proper pipe alignment. It will not leak and is intended to
have some exibility.
Note
Water Inlet
Water Outlet
Top View
Front View
IN
OUT
Wall Wall
Incoming
Water
Supply
Sediment Filter
Whole House
Filter
Outgoing
Water to
House
Water to Home
Water
Softener
Alternative
Bypass
Solution
Tank
Water
Filter
Injection Pump
Iron
Manganese
Filter
Sediment Filter
Iron
Manganese
Filter
Water
Softener
Alternative
IN
OUT
Wall Wall
Sediment Filter
Top View
Incoming
Water
Supply
Chemincal
Injector
Pump Tubing
Solution Tank
Chemincal Injector
Pump
Whole House
Iron & Manganese Filter
Whole House
Water Filter
Drain Line
Barb
Spigot
Outgoing
Water to
House
Split Ring
Quick Connect Nut
O-Ring
Part Description Qty.
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male
NPT Assembly (2): O-Rings (2),
Split Rings (2), and Connectors (2)
2
IRON & MANGANESE FILTER SYSTEM COMBO • 11
3. Install the ttings into the INLET and OUTLET sides of the bypass valve. Follow the diagram supplied with the tting.
4. Connect the incoming water supply to the tting on the INLET side of the bypass valve.
5. Connect the outgoing water supply to the OUTLET side of the bypass valve.