User manual

45 Power-Saving
46 FactoryDefault
47 ScanPeriod
48 Playback
49 SDCardFormat
50 Brightness
"
"
"
5. Technicaldata
Radio-Frequency 2,4GHz
Modulation GFSK
Radiorange(max.) 150m(openspace)
OperatingVoltage 5V DC(mainsadapter)
Currentconsumption 340mA
Channels 4
Picturesensor 1/5”CMOS
Viewingangle approx.39°horizontal
Lightsensitivity 1-8Lux(w/oIR-LEDs)
Illumination 9InfraredLEDs
Illuminationdistance max.3m
Microphone builtin
Protectionclass IP66
Dimensionswithoutantenna(mm) 92xØ42
Operatingtemperature -10°Cto+40°C
OperatingVoltage 5V DC(mainsadapter)
Currentconsumption 700mA
Lithiumrechargeablebattery 3,7V,1250mA
Screen 3,5” TFT-LCD
Resolution(Pixel) 320x240(QVGA)
Framerate max18fps
Recordingformat AVI
storagemedium SDcard(max.32GB)
max.recordingcapacityinhours 4(2GBSD-card)/17(8GB)/
34(16 GB)/70(32GB)
loudspeaker builtin
Protectionclass IP20
Dimensionswithoutantenna(mm) 130x90x27
Operatingtemperature 0°Cto+40°C
OperatingVoltage 230V~50Hz
5V A
MainsAdapter
Systemdata
CameraDF20K
MonitorDF25AM
Output ,1,0
(=8,8cm)
6. Safetyinstructions
7. Location of equipment
The following instructions are provided for your safety and satisfaction during
operation of the device. Note that non-observance of these safety instructions
results in significant risks ofaccident.
If this point is notheeded life and health is endangered.
Do not leave small children unsupervised with the device, packaging
material or small parts. Otherwise there is a risk of fatal injury due to
choking or suffocation.
Do not damage any gas, electricity, water or telecommunication lines
during drilling and fixing work. Otherwise there are dangers of fire,
personal and fatal injury.
Treat the cables carefully. Lay these so that they cannot be damaged and
do not present any tripping hazard. Otherwise there are dangers of fire,
personal and fatal injury.
If you use the device for monitoring babies or small children ensure that
the camera and cable are out of reach of children. Otherwise there is a
risk to life and limb!
Do not pull the cables over sharp edges and do not crush or crimp them
elsewhere. Otherwise there are dangersof fire, personal and fatal injury.
Prevent the device from coming into contact with moisture and do not
submerge in water. Otherwise thereis a danger of fatal injury.
Only operate the device from the supplied power supply. Before
connecting the power supply to the mains, ensure that the mains current
complies with 230 V ~, 50 Hz and is fitted with a fuse according to
regulations. Otherwise there are dangersof fire and fatal injury.
Non-observance of these instructions puts property at risk
of damage.
Protect the equipment and the cables against strong magnetic or
electrical fields and against strongmechanical loads and vibrations.
Do not place the equipment near fire, heat or in areas of high
temperature.
Only use the equipment with the supplied original parts or original
accessories.
Do not connect any damaged device (e.g. damage in transit). Repairs to
the equipment must only beperformed by specialists.
Remove the mains adapter from the mains outlet when the device is not
required for a longer time.
Before mounting the camera check the wireless reception from the desired
location. Observe the following points:
Position the camera so that no direct light or sunshine falls on the lens
otherwise the picture may become overexposed. Remember that the
position of the sun changes. Check the camera image before mounting.
Provisionally connect and commission the device and hold the camera in
the desired position. If necessary, change the camera position until you
have found the desired view.
Select the distance between the camera and the subject according to the
level of detail desired.
Danger!
Attention!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
22 - GB