Operation Manual

(Preparation of the Separated Flash Unit)

2 Set the channel of the separated (wireless) flash unit to the

same channel as the flash unit attached to the camera.

1 Place the other flash unit in the desired position.

2 Turn on the power switch (ON).

3 Press the flash mode button (MODE) a number of times

to display P-TTL MASTER on the LCD panel.

4 Press the setting button (SET) and rotate the

adjustment dial to display SLAVE.

5 Press the setting button (SET) to complete the setting.

6 Set the same channel (CH1 through CH4) of the flash

unit attached to the camera from the function menu.

• Refer to “Using the Function Menu” (page 36) for

details on the function menu.

7 Press and hold the function button ( ) to complete

the setting.

• The two flash units must be set to the same channel,

otherwise the separated flash unit will not discharge.

(Photographing)

3 Confirm that both flash units are fully charged, and take the

photograph.

A lamp on the separated flash unit will blink.

Wireless mode (SLAVE)

AF360FZ_540FGZ.book Page 44 Friday, December 20, 2013 6:11 PM