Operation Manual

50
2
n Slave Mode Setting
To properly control the slave flash, it is necessary to set slave
mode settings from the function menu.
1 Turn on the power switch (ON).
2 Press and hold the function button ( ).
3 Rotate the adjustment dial to display SL on the LCD panel.
4 Press the setting button (SET) to blink SL1 or SL2.
• The flash will not discharge properly if slave mode was
set to the wrong mode. It may not discharge at all or may
discharge simultaneously with the control flash.
5 Rotate the adjustment dial to select SL1 or SL2.
6 Press the setting button (SET) to complete the setting.
• To exit the function menu, press and hold the function
button ( ).
•In SL2 fluorescent lamps flicker may contribute to flash
unit’s erroneous firing on rare occasions.
SL1: When photographing in wireless mode.
SL2: When photographing with slave flash
(not using wireless function).
Slave mode
AF360FZ_540FGZ.book Page 50 Friday, December 20, 2013 6:11 PM