Operation Manual

4
To reduce the risk of hazards, use only a CSA/UL certified power supply
cord set, cord is Type SPT-2 or heavier, minimum NO.18 AWG copper,
one end with a molded-on male attachment plug cap (with a specified
NEMA configuration), and the other is provided with a molded-on female
connector body (with a specified IEC nonindustrial type configuration)
or the equivalent.
Warning
Be sure to store the battery out of the reach of small children. Placing it in
their mouths may cause an electric shock.
If any leakage from the battery should come in contact with your eyes,
it may cause a loss of sight. Flush your eyes with clean water and get
medical attention immediately. Do not rub them.
Caution
Only use the specified battery with this camera. Use of other batteries may
cause an explosion or fire.
Do not disassemble the battery. Disassembling the battery may cause
an explosion or leakage.
Remove the battery from the camera immediately if it becomes hot
or begins to smoke. Be careful not to burn yourself during removal.
Keep wires, hairpins, and other metal objects away from the + and -
contacts of the battery.
Do not short the battery or dispose of the battery in fire. This can cause
an explosion or fire.
If any leakage from the battery should come in contact with skin or clothes,
it may cause irritation to the skin. Wash the affected areas thoroughly with
water.
Precautions for D-LI92 Battery Usage:
BATTERY MAY EXPLODE OR FIRE IF MISTREATED.
- DO NOT DISASSEMBLE OR DISPOSE OF IN FIRE.
- DO NOT CHARGE EXCEPT SPECIFIED CHARGING CONDITION.
- DO NOT HEAT ABOVE 140°F / 60°C, OR SHORT CIRCUIT.
- DO NOT CRUSH OR MODIFY.
About the Battery
WG10_OPM_ENG.book Page 4 Friday, February 1, 2013 5:30 PM