Service Manual
8
5.
Always remain with the patient throughout therapy session to provide
direct supervision.
6.
Monitor patient view on tablet; select and change activities as desired.
Note: If sensors lose synchronization or headset loses tracking, turn off entire
system then back on to reset. Headset is turned off and on using the power button.
Sensors are turned off and on by placing them in the powered charging station and
removing them again.
7.
When planned therapy experiences are complete, press “End Session” on
tablet. Patient will be returned to the Hide and Seek experience without a
tracked avatar. Gaze interactions will still function.
8.
View patient results on tablet. You may also switch to the Notes tab for a
summary of session and activity times.
Section 5: SYSTEM REMOVAL
1.
Remove sensors and bands.
2.
Remove headset from patient’s head.
3.
Power off headset by pressing and holding onto the power button for
approximately 5 seconds.
4.
Log out of tablet and power off tablet.
5.
Clean headset and sensors with institutional approved sanitizing wipes*.
6.
Connect tablet and headset to their respective power cords.
7.
Return all sensors to sensor charger. Green LEDs should be noted on
sensors when placed correctly in the charging station.
8.
Store and label bands for future individual patient use.
9.
Ensure REAL
Immersive System Case is plugged in and component LED
lights indicate charging.
10.
Sufficiently charge all components after each use and prior to next use
for 60 minutes.
Note: Standard operation is to power cycle and relaunch application between
therapy sessions to reestablish system connections. Therefore, it may be necessary
to power cycle the headset and/or restart the application on the tablet in between
therapy sessions.
*Handle the lenses on the headset carefully to avoid smears or scratches. Wipe
lenses with a soft cloth for cleaning as needed. Clean outer and inner plastic com-
ponents of headset with institutional approved sanitizing wipe. Do not use petro-
leum-based compounds, acids, caustics, or chlorinated solvents to clean or lubricate
any parts. Use only water-based solvents for cleaning.