Service Manual

3
OPERATOR PROFILE
Operators of the REAL Immersive System should be trained in rehabilitation therapy.
Note: These rehabilitation exercises are intended to be conducted in a clinical
environment and prescribed and supervised by a medical professional trained in
rehabilitation therapy. Rehabilitation therapy treatment and technique decisions will
vary based on the clinical judgement of the treating medical professional. A medical
professional must be present at all times to provide direct supervision throughout
course of therapy.
OPERATING PROCEDURE
Note: Prior to first time use, router must be configured and connected to the local internet.
Note: These rehabilitation exercises are intended to be conducted in a seated posi-
tion. The patient must be seated at all times when the system is in use.
SECTION 1: GETTING STARTED AND CHARGING COMPONENTS
1. Remove REAL Immersive System Case from the shipping container.
2. Connect the REAL Immersive System
Case to its power cord (AC adapter
power cord). Plug the power cord into
a grounded electrical outlet. Ensure
the power receptacle is connected to
a supply mains with protective earth.
3. Ensure sensors with white sides facing forward are in their corresponding size
slots on the sensor charger. LED lights on sensors will show flashing red,
flashing green, or solid green to display charging status.
4. Ensure the headset is connected to its power cords (AC adapter power cord
and USB-C cord). LED lights on top of headset will show blinking green or
solid green to indicate charging status.
5. Ensure the tablet is connected to its power cord (USB-C cord).
Solid Green: Full battery